A wire twister tool can be used to speed up the stitching process. plastic cable ties can be used instead of wire. many stitch and glue builders are finding these ties to be very convenient and faster to tighten. they are also easier to snip off and can be sanded or cut flush once the glue has cured.. Stitch and glue building is the name given to boat building using plywood sheets held together by copper wire, string, cable ties, or some other method. the joint is then glassed over – on larger boats the copper wire may be left in, but on smaller craft it is usually cut out. an epoxy fillet. This video shows how to wire, or "stitch" the stern deck. watch the stitch and glue construction of a pygmy kayak kit! this video shows how to wire, or "stitch" the stern deck. copper wire.
The middle fit together just fine, and i was able to stitch it together with copper wire and glue it. the ends however would not come together, so i added some weights and mashed the ends together then filled any gaps with thickened epoxy. the deck actually stuck out about a half an inch over the edge on the front and back ends.. Variously called "stitch and glue", "stitch and tape" or "tack and tape" this method involves joining plywood panels with wire ties, then applying fiberglass and epoxy to either side of this joint. this strong and lignt technique was first used in great britain on the mirror dinghy.. Stitch-and-glue construction, along with the development of epoxy and modern mahogany marine plywood, has revolutionized and revitalized wooden boat building. this method of building is not only stronger, lighter, and faster than traditional wooden boat building, but it also takes far less skill. here's how a clc stitch-and-glue kayak is assembled..
